Thank you guys, Will try both solutions.
Dragan On Fri, Jun 3, 2011 at 11:06 AM, Josh M. Patten <[email protected]>wrote: > If you’re manually configuring the audiocodes gateways you can add a > source number manipulation under Protocol Configuration >> Manipulation > Tables >> Source Number IP -> Tel > > For your scenario, try the following settings: > > Dest Prefix > > Source Prefix > > Stripped from left > > Stripped from right > > Prefix to add > > Suffix to add > > Number of digits to leave > > Source IP address > > NPI > > TON > > * > > 12xx > > 0 > > 4 > > 5149087777 > > > > 255 > > * > > Not Configured > > Not Congfigured > > > > > > Josh Patten > > Brazos County Network Engineer > > 979.361.4676 > > > > *From:* [email protected] [mailto: > [email protected]] *On Behalf Of *Michael Picher > *Sent:* Friday, June 03, 2011 9:40 AM > *To:* Discussion list for users of sipXecs software > *Subject:* Re: [sipx-users] Caller ID based on caller's extension with > multiple gateways > > > > another way to do this is to use phantom gateways and branches... > > > > branches secure gateways within a dial plan entry. > > > > so, make a 12xx branch, a 15xx branch and a 17xx branch > > > > make unmanaged gateways for each branch pointing to the mediant 1000's ip > address. (gw12xx, gw15xx, gw17xx). > > > > On the unmanaged gateways set the caller-id you want to force outbound. > > > > Put all your 12xx users in the 12xx branch, etc. > > > > Put only the phantom gateways in the outbound dial plan entries. > > > > Thus you'll avoid forcing caller-id on a per user or group basis and do it > by what gateway is used! > > > > Mike > > > > > > > > On Thu, Jun 2, 2011 at 3:35 PM, Dragan Jurkovic <[email protected]> > wrote: > > My setup is as follows: Sipx 4.4, 3 user group with different > extension ranges (12xx, 15xx, 17xx), remote site with extension range > 11xx connected via VPN and site-to-site gateway/dial plan, outside > calls handled by Audiocodes Mediant 1000 PRI. > What I am trying to achieve is: > - when calling remote site to have outgoing caller id as extension > number (this is anyway default setting). > - when calling outside through Mediant to have different caller ids > for every extension group - for example if call is placed from 12xx > extension to have caller id 5149087777, when calling outside from 15xx > extension to have caller id 5148455201, etc. > Obviously cannot achieve this via user groups because calls to remote > site will show 514NNNNNNN caller id on remote site. > Can Mediant be programmed to change called id perhaps? > >
_______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users/
