We aren't concerned about the old voicemail settings at this point. How do we setup the voicemail from scratch. We need to setup a voicemail for each phone and the 4 individual companies also need to have a general mailbox. How do we setup the voicemail for the phones and any general mailboxes?
It is almost assured that doing a non-linear upgrade will cause issues especially with voicemail and email forwarding. For you I recommend doing a fresh 4.0.5 install, restore your configuration and voicemail, then perform a 4.2.1 upgrade, test everything and make sure it's running, then perform the 4.4 upgrade, then test everything and make sure it's running. No other way is supported. From: [email protected] [mailto:[email protected]] Sent: Tuesday, August 23, 2011 12:40 PM To: '[email protected]' Cc: '[email protected]' Subject: [sipx-users] Email and VoiceMail Issues After Upgrade From Sipexs 4.0.1-015823 to SipXecs 4.4.0 We didn't do an upgrade. We did a fresh install to a virtual machine and restored the config. I see that Josh Patten upgraded from 4.0.5>4.2.1>4.4.0 but I have a lot of reponses on other issues and may have missed an email upgrading to 4.2.1 1st. So doing a fresh install of 4.4.0 as we did and restoring the configs can also cause issues? If so what are the issues. Will it cause the issues described here? like you were advised, not to do a straight upgrade. you should have gone to 4.2.1 then4.4.0. On Aug 23, 2011 11:06 AM, <[email protected] <https://mail.itnetworkconsultants.com/owa/redir.aspx?C=cb23fa21598b4be28b16 92807d84ed21&URL=mailto%3asupport%40itnc.biz> > wrote: > We recently had to upgrade our client's phone system From Sipexs > 4.0.1-015823 to SipXecs 4.4.0 because they were unable place or receive > outside calls. I had submitted an email on that issue with subject of "Re: > [sipx-users] Attempt To Make Callls But Never Successully > Invite Sent Over and Over" We were able to get the phone system > functioning again by installing 4.4 on a virtual machine. However their > voicemail isn't working and they had a Ringtone setup for each individual > company so they can easily distinguish which company is receiving the call. > After the restore the ringtones are no longer working. We tried to restore > the latest voicemail config that was backed up on the 4.0.1-015823 system, > but it says it was invalid or incomplete. On the ringtone issue, they have > tried to setup the ringtones as they had before and they say it appears to > accept the changes, but all calls ring the same no matter what. Are there > any compatibility issues with the voicemail between these versions and what > do we need to do to resolve the voicemail issues. Does anyone have any > suggestions on the Ringtone issues? They are using PolyCom SoundPoint IP > 650 and 330 phones. I do not know what firmware each has yet or if they > are all the same, but can get that if needed.
_______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users/
