Simon Bryan wrote:
>
> Hi,
> I am still having trouble with the ethernet card in my HPE40. It is an
> Intel Etnernet PRO 100 (aparently).
> I had trouble getting it to initialise but finally got it using a generic
> PCI driver from the list, ran smoothly for a while.
> The next time I restarted the bootup process 'found' an Intel Ethernet PRO
> 100 that it had nver found before, and neither would start until I disabled
> the eth1 in Linuxconf. All was well again for a while.
> I have had to restart the server again, now the card won't start at all,
> the bootup process gives 'insmod' as the reason. I have alternatively
> enabled both versions of the card in Linuxconf so that only eth0 or eth1
> was active, for the same result.
> If I remove them both then the server starts without error, but of course I
> have no network card enabled.
> Any clues as to where to go from here would be appreciated. Given that the
> card ran flawlessly for several days and the problem only occurs on a
> reboot, I don't think the card is faulty.
posting /etc/conf.modules might be beneficial...
--
Andrew Dorrell PhD. Research Engineer
Canon Information Systems Research Australia Phone: 61 2 9805 2224
1 Thomas Holt Drive, North Ryde, NSW 2113. Fax: 61 2 9805 2865
--
SLUG - Sydney Linux User Group Mailing List - http://slug.org.au/
More Info: http://slug.org.au/lists/listinfo/slug
