[slurm-dev] Re: smap / sview / pam_slurm.so not build

[Vsevolod Nikonorov]

Uwe Sauter писал 2014-05-16 11:31:

Hi.

pam-devel was already installed but pam_slurm.so was not build....

Try to search something about pam in ./configure output.

After installing ncurses-devel and gtk2-devel both smap and sview were build.

Thanks for the help,

    Uwe

Am 16.05.2014 09:20, schrieb v.nikonorov:

Uwe Sauter писал 2014-05-16 11:04:

Hi all,

Hi,

 I'm new to slurm.

 I built slurm with

 ./configure --prefix=/opt/system/slurm/14.03.3
--with-munge=/opt/system/munge/0.5.11 --enable-pam
 make
 make install

 and recognized that smap and sview are not installed:

You are possibly missing development libraries for ncurses/gtk2/pam in your system, for example, in Centos relevant packages are pam-devel, gtk2-devel and ncurses-devel.

 # pwd
 /opt/system/slurm/14.03.3/bin
 # ls
 sacctￜￜￜￜ sallocￜￜ sbatchￜ
scancelￜￜ sdiagￜ sprio sreportￜ sshareￜ
strigger
 sacctmgrￜ sattachￜ sbcastￜ scontrolￜ sinfoￜ
squeue srunￜￜￜￜ sstat

 Do I have to build smap and sview by hand? Is it only useful on

certain types of clusters like BlueGene or Cray? (If so this should be

reflected in the documentation.)

 Additionally it seems that the PAM module is not build by the

Makefile. Is this intended behavior? I can understand that you refrain

from installing the PAM module because the installation destination
might not be the same on all systems but I'd expect the module to be
built when I explicitly configure Slurm to use PAM.

 Regards,

 ￜￜￜ Uwe Sauter

Email secured by Check Point

Email secured by Check Point

--
Никоноров Всеволод Дмитриевич, ОИТТиС, НИКИЭТ

Vsevolod D. Nikonorov, JSC NIKET