Update - cp today - pwr brick for injector *very hot* - can't bring up radio w/sm - turns out Motorola Canopy lightning arrestor in attic had taken some type of spike/surge/hit - circuit board with RJ45 ports inside has nickle size burnt spot and is hotter than pwr brick - removed LA and green and orange lights on radio came on nice and solid - still no blue Tx/Rx light and can't get into radio - will drop the mast and pull the ABT tomorrow - probably toast - will check for water.
Mickey ----- Original Message ----- From: "Blazen Wireless" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, September 02, 2003 8:59 PM Subject: Re: [smartBridges] Lost ether. / radio > Try another POE and or power adapter and check the wiring Cat 5 possibly > water got into the jacket or at the connector... > Also if it is a NEWER one with the waterproof connector people say they have > been seeing issues with water still getting in so I would start there 1st. I > also had an ABT case start to warp with a big enough gap on the edge to let > water in and a few other people are starting to see the same issue as well. > > Good luck and let us know what you find to confirm my suspicions of water > damage either in the unit itself or in the pigtail cat 5 connector. > > > ----- Original Message ----- > From: "Mickey" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Tuesday, September 02, 2003 6:04 PM > Subject: Re: [smartBridges] Lost ether. / radio > > > The device IS NOT functioning either on the wireless side or on the ether. > side. > > The only light working on the radio is the orange and it constantly flashes. > > The light on the power injector also flashes until the cat 5 that runs to > the radio is unplugged from the power injector - at that point, the light on > the power injector stays on solid - when the cat5 from the radio is plugged > back into the pwoer injector, the green light on the power injector starts > flashing again. > > Mickey > > ----- Original Message ----- > From: "sB Tech Support" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Tuesday, September 02, 2003 6:37 PM > Subject: RE: [smartBridges] Lost ether. / radio > > > > This is pretty new case. Is the device functioning now after pulling the > > cat5 cable? Do you mean there isn't Cat5 cable connected earlier? Does > > both the Ethernet and wirelessly working (can associate and pass > > traffic)? > > > > Alex > > sB Tech Support > > [EMAIL PROTECTED] > > > > > > -----Original Message----- > > From: Mickey [mailto:[EMAIL PROTECTED] > > Sent: Wednesday, September 03, 2003 6:08 AM > > To: [EMAIL PROTECTED] > > Subject: [smartBridges] Lost ether. / radio > > > > Have a customer using ABTot since early June - powered down everything > > to > > leave for the holiday weekend - came back today and powered up - on the > > radio no blue (tx/rx) light, no green (pwr) light, flashing orange light > > and > > flashing green light on pwr injector/pod - no link light on his NIC when > > connected to the pwr injector - when he pulls the cat5 running to the > > radio > > from the pwr injector, the pwr injectors green light stays on solid. > > > > This radio was out of a group from 3/24/03 or 5/1/03. > > > > Taking the recovery utility and a new pwr injector to his house. > > > > Does this fit any of the various failure scenerios seen over the last > > three > > months? > > > > Thanks for any suggestions, > > Mickey > > > > > > > > ----------ANNOUNCEMENT---------- > > Don't forget to register for WISPCON IV > > http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm > > > > The PART-15.ORG smartBridges Discussion List > > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > > smartBridges <yournickname> > > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe > > smartBridges) > > Archives: http://archives.part-15.org > > > > ----------ANNOUNCEMENT---------- > > Don't forget to register for WISPCON IV > > http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm > > > > The PART-15.ORG smartBridges Discussion List > > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > smartBridges <yournickname> > > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe > smartBridges) > > Archives: http://archives.part-15.org > > ----------ANNOUNCEMENT---------- > Don't forget to register for WISPCON IV > http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > smartBridges <yournickname> > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe > smartBridges) > Archives: http://archives.part-15.org > > > ----------ANNOUNCEMENT---------- > Don't forget to register for WISPCON IV > http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) > Archives: http://archives.part-15.org ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
