Hi Carl,
If you are able to ping to the Mandrake Firewall/Gateway means,
it shouldn’t be any problem in the wireless link. Please verify the DNS
& GW entries in your PC and PING using the GW and DNS IP address from the
client PC. If still unable to pass the traffic to the internet or outside the
firewall, then please check the firewall policy settings.
Thank you
Kind regards,
Seeni
![]()
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Carl A Jeptha
Sent: Friday, October 31, 2003
7:01 AM
To: [EMAIL PROTECTED]
Subject: Re: [smartBridges]
Microcell setup
I can ping and surf within my
private network (10.0.0.0). I cannot ping and surf outside in the public area.
I already have a Wavebolt system running for local work on the same network.
----- Original Message -----
Sent: Thursday,
October 30, 2003 5:30 PM
Subject: RE:
[smartBridges] Microcell setup
Hi
Carl,
From
the DWL 900AP + when you operate in a wireless client mode and you try to
associate to the repeater, are you able to ping the aPPO in repeater mode and
get a response?
Vasu
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On
Behalf Of Carl A Jeptha
Sent: Friday, October 31, 2003
6:05 AM
To: [EMAIL PROTECTED]
Subject: [smartBridges] Microcell
setup
I have two Airpoint Pro and one
Dlink 900ap+
I would like to start a microcell
with them. Below is what I think must be done.
2. Mandrake Firewal/Gateway
4. Airpoint Pro Outdoor - set in AP
Mode
5. Airpoint Pro Outdoor - set in
Repeater Mode
6. DWL 900AP+ - set in Wireless
Client Mode
Right now in this test setup I
cannot reach the Internet. Although nthe same Gateway is handling other
traffic.
|
<<image001.jpg>>
