|
That setup should work. However I had a similar
problem with reaching the Internet on IP-Cop with the arangement below.
2. IP-Cop
Firewal/Gateway
5. Airpoint Pro Outdoor - set in AP
Mode
6. airBridge
7. Client
Network
It would ping IP-Cop local and Internet
interfaces but not the Internet. The solution was to replace 4. airBridge
with airPoint in Client Bridge mode;
2. IP-Cop
Firewal/Gateway
3. Ethernet
4. Airpoint Pro Outdoor - set in
Client Bridge mode
5. Airpoint Pro Outdoor - set in AP
Mode
6. airBridge
7. Client
Network
Regards,
Wayland.
----- Original Message -----
Sent: Friday, October 31, 2003 3:08
AM
Subject: RE: [smartBridges] Microcell
setup
Hi Carl,
If you are able to ping to the
Mandrake Firewall/Gateway means, it shouldn�t be any problem in the wireless
link. Please verify the DNS & GW entries in your PC and PING using the GW
and DNS IP address from the client PC. If still unable to pass the traffic to
the internet or outside the firewall, then please check the firewall policy
settings.
Thank you
Kind regards,
Seeni
![]()
-----Original
Message-----
From:
[EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]
On Behalf Of Carl A
Jeptha
Sent: Friday, October
31, 2003 7:01 AM
To:
[EMAIL PROTECTED]
Subject: Re: [smartBridges] Microcell
setup
I can ping and surf within my
private network (10.0.0.0). I cannot ping and surf outside in the public area.
I already have a Wavebolt system running for local work on the same
network.
----- Original Message -----
Sent:
Thursday, October 30, 2003 5:30 PM
Subject: RE:
[smartBridges] Microcell setup
Hi
Carl,
From
the DWL 900AP + when you operate in a wireless client mode and you try to
associate to the repeater, are you able to ping the aPPO in repeater mode
and get a response?
Vasu
-----Original
Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Carl A Jeptha
Sent: Friday, October 31, 2003 6:05
AM
To:
[EMAIL PROTECTED]
Subject: [smartBridges] Microcell
setup
I have two Airpoint Pro and one
Dlink 900ap+
I would like to start a
microcell with them. Below is what I think must be
done.
2. Mandrake
Firewal/Gateway
4. Airpoint Pro Outdoor - set in
AP Mode
5. Airpoint Pro Outdoor - set in
Repeater Mode
6. DWL 900AP+ - set in Wireless
Client Mode
Right now in this test setup I
cannot reach the Internet. Although nthe same Gateway is handling other
traffic.
|
<<image001.jpg>>
