...............the bend in the aileron shaft can be cut to 32 degrees. This
results in a
: mechanical advantage that doubles the effective torque and resolution of
: the servo.

My previous mail was trying to point out that servo overloading with
aileron input at high speed is a perceived problem at the engineering level
lead by  an error perception. The error gave us a static model of the
problem that the speeding wing in an initial fixed angle of attack remain
unchanged at any time and any aileron angle. It also assume that the
aileron may reach at final set angle in zero time. Most of the analysis I
review follow that assumption. The analysis result will lead us to believe
that aileron related servo loading (or overloading) is dominated by air
speed. I have seen huge numbers at the analysis output.

Lets consider this:
(given sub-sonic air speed).
1) Servo will not step to final angle in zero time.
2) Wing will begin bank before aileron has reached to its final setting.
3) A banking wing produce a lower effective aileron angle at any air speed.
4) A certain banking moment force is required to aileron of a specific
plane at a given bank rate at any air speed
5) To satisfy a given bank rate at any air speed, aileron displacement
angle is inversely proportion to air speed. In other words, higher air
speed need less aileron input, and vice versa.
6) Therefore servo loading is proportional to bank rate at any air speed.

I trust you all will enjoy RDS from now, slope or thermal.

YK

RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to