At 06:46 PM 3/7/2008, Brian Henderson wrote:
>I just picked up a net5501-60 and a Compact Flash card to build a
>router, and I have flashed the card and it works, but only on a warm
>boot. The card is not detected when the power is plugged in, but it is
>detected if you press the reset button or type reboot over the serial
>console. Rebooting from within m0n0wall works.
>
>Is there a setting to pause before detection of the flash card, or
>should I be looking for a new card?
I just unpacked a new unit with this BIOS and found a different issue.
POST: 012345689bcefghips1234ajklnopqr,,,tvwxy
comBIOS ver. 1.33 20070103 Copyright (C) 2000-2007 Soekris Engineering.
net5501
0256 Mbyte Memory CPU Geode LX 434 Mhz
Pri Sla CF CARD 1GB LBA Xlt 983-32-63 990 Mbyte
Slot Vend Dev ClassRev Cmd Stat CL LT HT Base1 Base2 Int
-------------------------------------------------------------------
0:01:2 1022 2082 10100000 0006 0220 08 00 00 A0000000 00000000 10
0:06:0 1106 3053 02000096 0117 0210 08 40 00 0000E101 A0004000 11
0:07:0 1106 3053 02000096 0117 0210 08 40 00 0000E201 A0004100 05
0:08:0 1106 3053 02000096 0117 0210 08 40 00 0000E301 A0004200 09
0:09:0 1106 3053 02000096 0117 0210 08 40 00 0000E401 A0004300 12
0:14:0 12B9 1008 07000201 0101 0210 00 00 00 0000E501 00000000 10
0:20:0 1022 2090 06010003 0009 02A0 08 40 80 00006001 00006101
0:20:2 1022 209A 01018001 0005 02A0 08 00 00 00000000 00000000
0:21:0 1022 2094 0C031002 0006 0230 08 00 80 A0005000 00000000 15
0:21:1 1022 2095 0C032002 0006 0230 08 00 00 A0006000 00000000 15
1 Seconds to automatic boot. Press Ctrl-P for entering Monitor.
It just freezes here for 60 seconds before going on to boot. This is
after a power cycle, or resetting via the watchdog or just a plain
shutdown -r now. The same flash on another board boots as expected.
and then 60 seconds later (it seems to be exactly 60 seconds)
/boot.config: -hConsoles: serial port
BIOS drive C: is disk0
BIOS 639kB/261120kB available memory
FreeBSD/i386 bootstrap loader, Revision 1.1
([EMAIL PROTECTED], Tue Jan 15 02:49:13 EST 2008)
Loading /boot/defaults/loader.conf
/boot/kernel/kernel text=0x29bc7c data=0x2def4+0x1c498
syms=[0x4+0x39d20+0x4+0x49bd4]
|
Hit [Enter] to boot immediately, or any other key for command prompt.
Booting [/boot/kernel/kernel]...
The webpage says
"It is not recommended to "downgrade" a BIOS to an older version than
the one a board is supplied with."
Can someone from Soekris comment / help ? I am using FreeBSD 6.3 with
images build via nanobsd.
What has changed in 1.33 ? There is no change log.
---Mike
_______________________________________________
Soekris-tech mailing list
[email protected]
http://lists.soekris.com/mailman/listinfo/soekris-tech
