As stated below. JP15 isn't really enough to power an analog device reliably.
Try if it you wish - but you may fry the Soekris board. BTW - sorry for the html earlier - I was using OWA. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Darrick Hartman Sent: 12 November 2008 13:54 To: [email protected] Subject: Re: [Soekris] net5501 irq conflicts (digium tdm410) Felix Kronlage wrote: > On Wed, Nov 12, 2008 at 07:09:48AM -0000, Andrew Thomas wrote: > >> Also, I suppose you realise that you will have trouble making analog handsets ring - as the TDM cards require a 12v/5v input (as supplied by a PC power supply - but not available on a soekris board)? > > There is a 12V connector, we measured it and attached it to the > Digium Card. Take a look at this page. I added the pictures this week and provided part number for the connector required to use with the JP15 connector. http://wiki.soekris.info/5501_Interfaces Note that you only need to provide 12V IF you have an FXS module on the card. If it's loaded with FXO modules, then no power is required. Also be careful with the amperage. You only get about 1A from the JP15 connector. Darrick _______________________________________________ Soekris-tech mailing list [email protected] http://lists.soekris.com/mailman/listinfo/soekris-tech _______________________________________________ Soekris-tech mailing list [email protected] http://lists.soekris.com/mailman/listinfo/soekris-tech
