Yes I checked the jumpers Anyway in master mode there are no jumpers, and I also have a problem in this mode (duplicate hd entrty) I also tested another IDE cable from a 5501 mounting kit
Le mardi 3 février 2009 14:39, Wim Vandeputte Mailing list only a écrit : > you are sure that the cable select jumper is in the right place on the > disk? > > On Mon, Feb 02, 2009 at 11:23:25PM +0100, Sebastien MONOT wrote: > > Hello, > > > > I have the following issue with a net4801-60 : i cannot succeed in seing > > both CF and hd at boot > > - CF is a Sandisk Ultra II 4 Gb > > - HD is either Samsung Spinpoint HM080GC or MMPO402H or Seagate Momentus > > 5400.3 160 Gb (hit the 134 Gb limit) and jumpered in CS mode > > - I tried ComBios versions 1.29 (default), 130 and 1.33 > > > > If Flash set to secondary : ComBios only displays the HD > > If Flash set to primary : ComBios only displays the CF > > > > If disk jumpered to master and no CF => ComBios only displays the HD > > twice > > > > In all cases no disks are detected at all during the subsequent PXE > > debian installation > > > > I had no problem with this board running OpenBSD for more than a year > > Same issue with a newer net4801-50 > > > > Am I missing something ? > > > > Thanks for your help > > > > Sebastien > > > > _______________________________________________ > > Soekris-tech mailing list > > [email protected] > > http://lists.soekris.com/mailman/listinfo/soekris-tech _______________________________________________ Soekris-tech mailing list [email protected] http://lists.soekris.com/mailman/listinfo/soekris-tech
