The mount for the 2.5" disk that I had fit over the mainboard area. It was a bit tight, had to be careful to not shave cables when assembling, but it worked. I did have a much smaller and likely cooler drive than the sizes being discussed here.
On Sun, Feb 21, 2010 at 5:38 PM, Henrik /KaarPoSoft <[email protected]>wrote: > > >> However, the specs say that it has form-factor 2.5" x 1/6H. > >> Will it fit in the net5501 standard case with the 2.5" HDD mounting kit? > >> > > > > I don't think so, it's really pretty tight in there. > > > > But if you do not need the PCI expansion slot, you could simply bolt > > the disk down over on that side of the cabinet by drilling four > > holes in the bottom of the cabinet. > > > > Or, for more "interrim" installation: a couple of shots with the > > glue-gun or a wad of double-stick tape... > > > > > Sounds like a good solution (bolting it on the PCI side of the cabinet, > that is; not the double-stick tape :-)) > > I guess I should just go ahead and order the thing, and see if I can get > it to work... > > /Henrik > _______________________________________________ > Soekris-tech mailing list > [email protected] > http://lists.soekris.com/mailman/listinfo/soekris-tech > -- mailto:[email protected] // GoogleTalk: [email protected] GV: 202-642-1717
_______________________________________________ Soekris-tech mailing list [email protected] http://lists.soekris.com/mailman/listinfo/soekris-tech
