On Feb 19, 2011, at 1:39 AM, Jed Clear wrote:
> My recollection is that the error LED for for a few seconds during cold boot
> is normal. If it stays on you have an issue.
>
> My first thought is that you have a speed mismatch on the serial line.
> Perhaps it didn't stay the same speed after the reboot, or you restarted the
> terminal emulation and it defaulted back to 9600. That's one reason I
> always go into CommBIOS first thing and set it to 9600, which is the default
> for the rest of the world. Many less problems that way.
>
> After that, power supplies are a frequent issue, as the other poster
> mentioned. I'm on my third. Soekris replaced the first one under warranty
> and when it went, I bought something completely different.
>
> If you boot off the CF or HDD can you ping it on the network? Does the HDD
> even act like it's booting?
It turns out the board was "quasi-booting" because of the failed power supply.
Not so clever to not figure this out on my own.
Thank you all for the support.
Andrea.
----
Andrea Gronchi
[email protected]
_______________________________________________
Soekris-tech mailing list
[email protected]
http://lists.soekris.com/mailman/listinfo/soekris-tech
