Dear all, sorry to interfere here but I have some old Masslynx filesobtained by direct infusion from which I need experimental data such as collision cell pressure. would you have any solution for this. thank you very much best regards alain lesimple
On Friday, January 19, 2007 1:24:00 PM UTC+3, pjss wrote: > Dear All - can anyone help? > > I am trying to convert MassLynx 4.1 acquired .raw files into mzXML > files using the TPP Web Interface. When viewing these files in the > 'Browse Files' tab they are indicated as being 0 k in size. Naturally, > when you attempt to convert these to mzXML files, they fail with the > following command history shown below. The PC (Windows XP) used for > conversion has MassLynx 4.1 installed for the DAC library files. > I have also tried downloading an independent version of massWolf and > have been unable to get this to even load-up. > > Would anyone have any ideas as to the problem. Any help is very much > appreciated. > > Kind regards, > > Paul > > Commands for session VTFAYCFWY on Fri Jan 19 09:49:42 2007 > # BEGIN COMMAND BLOCK > ###### BEGIN Command Execution ###### > [Fri Jan 19 09:49:43 2007] EXECUTING: /usr/bin/readw > "c:\Inetpub\wwwroot\ISB\data\Myoglobin001.raw" p > OUTPUT: > Could not create dispatch > Cannot open file c:\Inetpub\wwwroot\ISB\data\Myoglobin001.raw > Saving output to c:\Inetpub\wwwroot\ISB\data\Myoglobin001.mzXML > Processing header > Calculating sha1-sum of RAW > Cannot open file c:\Inetpub\wwwroot\ISB\data\Myoglobin001.raw for sha-1 > calculation > END OUTPUT > RETURN CODE:65280 > ###### End Command Execution ###### > ###### BEGIN Command Execution ###### > [Fri Jan 19 09:49:44 2007] EXECUTING: /usr/bin/readw > "c:\Inetpub\wwwroot\ISB\data\MyoglobinBipA001.raw" p > OUTPUT: > Could not create dispatch > Cannot open file c:\Inetpub\wwwroot\ISB\data\MyoglobinBipA001.raw > Saving output to c:\Inetpub\wwwroot\ISB\data\MyoglobinBipA001.mzXML > Processing header > Calculating sha1-sum of RAW > Cannot open file c:\Inetpub\wwwroot\ISB\data\MyoglobinBipA001.raw for > sha-1 calculation > END OUTPUT > RETURN CODE:65280 > ###### End Command Execution ###### > # All finished at Fri Jan 19 09:49:45 2007 > # END COMMAND BLOCK > > -- You received this message because you are subscribed to the Google Groups "spctools-discuss" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/spctools-discuss?hl=en. For more options, visit https://groups.google.com/groups/opt_out.
