Dear all A few days ago we made first steps with Config Manager for all our network devices and ran into the problem, that with the current setup – where every device is polled with snmpv2 (because of the 64 bit counters for interface statistics) – we are not able to collect the current config.
We have tested this behaviour for several manufacturers: various enterasys switches and also cisco IOS routers. As soon as we switch back to snmpv1, everything works fine and we can then collect the actual configs of the above mentioned devices. So who of you does use snmpv2 for normal polling AND the Config Manager to collect the running configurations of infrastructure devices ? And could you give me advice, in what I did wrong so far ? Thank you and best regards, --Fritz. ___________________________ University of Bern Computer Services Department Fritz Buetikofer Senior IT Manager Gesellschaftsstrasse 6 CH-3012 Bern Switzerland Tel. +41 (0)31 631 3843 Fax. +41 (0)31 631 3865 Web. http://www.id.unibe.ch --- To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected]
