i JUST bought the 4x4 eastsheen minicube. when I opened it up to lube it, I
hadn't planned on taking out any pieces... but, when I did so, it ended up
knocking a few pieces out. I had to take an hour or so to re-assemble the cube.
When I was done, i was extremely happy.. it turned great.
Today the cube was dropped from approximately 3 ft up onto carpet (NOT by
me), and afterwards, it stopped working. U turns work, D works, L, R, F, B, etc
all work. However, I could not turn horizontally at the middle. IE, I could not
do any u or u' moves.
I took off all the center caps. i tried to figure out what was wrong. I noticed
that when all the center caps are off, you can see through between adjacent
sides. However, between the L and F faces, it seemed there was a piece jiggling
around in there, and I could not see through as I could on every other edge.
I tried to fix it. I couldn't.., all that I was able to do was end up
knocking out tons of pieces, and evnetually I decided to start ALL over. I
disassembled the cube completely.
I reassembled it. It took THREE HOURS. When I was done, after a little bit of
tightening and adjustment, the cube worked great.I was then playing with it a
little bit (using it to simulate a 2x2 cube, so I was doing only r, l, u, d,
moves, etc), when all of a sudden, I noticed that the same problem was
happening again!!!!!!!!!!
im about to try and fix it, but arrrrgghh!! what do I do??
David
---------------------------------
Yahoo! Mail
Use Photomail to share photos without annoying attachments.
[Non-text portions of this message have been removed]
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/speedsolvingrubikscube/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
