Hi.

I use a speedtouch adsl modem, BT broadband and redhat 7.3, and have 
been trying your drivers. I have read the howto and been on a couple of 
chat rooms trying to get things going. However, I'm still having problems.

Firstly, many times when running modem_run, it hangs. Sometimes it goes 
through almost straight away. Sometimes it starts to go through, gets to 
the point where the green light is flashing and stalls for a few 
secconds and then completes. Other times, it just hangs for ever. I've 
had it hang for 15 minutes and then connect! The log shows some 
problems. It says that modem_run version 1.1 has started, then 
"usb_control/bulk_msg: timeout" and lastly "usbdevfs: USBDEVFS_BULK 
failed dev 5 ep Ox85 len 512 ret -110". The same modem on the same phone 
line works from my WinME box, with perhaps a 20sec pause.

On the occasions that this stage works, I see log messages about 
timeouts, then modem_run says that the ADSL has synchronized and gives a 
download and upload speed. When running pppd (by the way, my ppp 
binaries got put in /usr/sbin, not /usr/local/sbin), things go through, 
IPs for DNS and local/remote are obtained. However, it says "not 
replaced existing default route to eth0 [192.168.0.1]" and this has 
caused me all sorts of problems. When I tracked this down (with help 
from the #linuxhelp chat), I was able to work around this by using route 
to change the default gateway to the remote IP. I then modify the 
/etc/resolv.conf file to include the new DNS entries, either by hand or 
using neat. At this point, I can ping things by IP, but can't resolve 
names.

I'm running kernel 2.4.18-5smp, and the latest drivers downloaded from 
your sourceforge site. I got the latest mgmt.o file from alcatel. I 
accepted the default secure firewall options from the redhat install.

Matthew



Liste de diffusion modem ALCATEL SpeedTouch USB
Pour se d�sinscrire : mailto:[EMAIL PROTECTED]?subject=unsubscribe

        

Reply via email to