There is a rear seam that meets with the valance.  The two pieces are sport
welded and a piece of molded body metal (like the trim on the top only in
mild steel) is tack welded on top of that junction to make it a smooth and
attractive joint.

The inner fender lip is parallel with the outer fender.  I am pretty sure
that the two are also spot welded together.  If the inner fenders are also
flared out, it may be a bit of work to reshape them to match the new fender
regardless of whether you use the entire fender of a section of it.

I suppose it is also possible to section the inner fender as well as the
outer.

Cheers,
Joe
----- Original Message ----- 
From: "Todd Bermudez" <[EMAIL PROTECTED]>
To: "Joe Curry" <[EMAIL PROTECTED]>; "NASS Spitfire" <[EMAIL PROTECTED]>;
"Spitfire List" <[email protected]>
Sent: Wednesday, February 08, 2006 9:09 AM
Subject: Re: Rear Wing Replacement


> Joe,
>
> Forgive me, what's a Rear Capper?  Also, how are they
> mated to the inner fender?
>
> I like the idea of cutting out what needs to be
> replace, but I do not know the extent of how much the
> fender was pulled out.  It has an odd dent here &
> there.  This makes me thing that it was pulled out a
> bunch so it might be hard to tell how to splice them
> back together??
>
> Thanks again,
>
> Todd Bermudez
> '67 GT6 MKI
> Cincinnati, OH

Your messages not reaching the list?
Check out http://www.team.net/posting.html

===  This list supported in part by The Vintage Triumph Register
===     http://www.vtr.org

===  Help keep Team.Net on the air
===     http://www.team.net/donate.html

===  unsubscribe/change address requests to [EMAIL PROTECTED]  or try
===  http://www.team.net/cgi-bin/majorcool
===  Other lists available at
===      http://www.team.net/mailman/listinfo
===  Archives at http://www.team.net/archive
===  http://www.team.net/the-local
===  Edit your replies!

Reply via email to