In a message dated 9/19/2008 8:39:10 P.M. Eastern Daylight Time, [EMAIL PROTECTED] writes:
So my question is has anyone replaced a yoke on a drive shaft? It's a splinned fit with what looks like a roll pin holding it in place. If this can be done I can probably pick up some used drive shafts and just use the yokes. ==AM== Well, yes, it's possible. It is held together as you say. However, it usually takes at least a 12-ton press, lots of patience (and possibly heat), and it probably wouldn't hurt to wait until the planets align and you've arranged for an expert in Voodoo or the like. Good luck. ;-) --Andy Mace *Mrs Irrelevant: Oh, is it a jet? *Man: Well, no ... It's not so much of a jet, it's more your, er, Triumph Herald engine with wings. -- Cut-price Airlines Sketch, Monty Python's Flying Circus (22) Triumph 10 / Herald / Sports 6 vehicle consultant, The Vintage Triumph Register: _http://www.vtr.org_ (http://www.vtr.org/) Check out the North American Triumph Sports 6 (Vitesse 6) and Triumph Herald Database: _http://triumph-herald.us_ (http://triumph-herald.us/) **************Looking for simple solutions to your real-life financial challenges? Check out WalletPop for the latest news and information, tips and calculators. (http://www.walletpop.com/?NCID=emlcntuswall00000001) _______________________________________________ Support Team.Net http://www.team.net/donate.html [email protected] http://autox.team.net/mailman/listinfo/spitfires http://www.team.net/archive
