The calculations are pretty basic, but you should have an engineer do them.
At 12:17 PM 3/5/2012, you wrote: >Is there any straightforward method to calculate a section modulus necessary >to install a cantilevered hanger? IE we'd be hanging unistrut from either >side of a beam and then extending out away from the beam with a "dead end" >piece of strut to hang our pipe. The issue is that trapezing this pipe >requires extensive scaffolding as the next beam is over top of high voltage >electrical distribution equipment that we can't work above. I get the feeling >this is a job for a PE but I'm open to suggestions. > >Mike Morey, SET, CFPS >Sprinkler Designer >BMW Constructors, Inc. >O: 317.651.0596 | C: 317.586.8111 >www.bmwc.com >-------------- next part -------------- >An HTML attachment was scrubbed... >URL: ><http://fireball.firesprinkler.org/mailman/private/sprinklerforum/attachments/20120305/2b86c138/attachment.html> >_______________________________________________ >Sprinklerforum mailing list >[email protected] >http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum Todd G. Williams, PE Fire Protection Design/Consulting Stonington, CT 860.535.2080 www.fpdc.com _______________________________________________ Sprinklerforum mailing list [email protected] http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum
