Did you provide new heads then? Ryan L. Hinson, PE*, SET** \ Burns & McDonnell Senior Fire Protection Engineer O 952-656-3662 \ M 320-250-5404 \ F 952-229-2923 [email protected] \ burnsmcd.com<http://www.burnsmcd.com/> 8201 Norman Center Drive, Suite 300 \ Bloomington, MN 55437 *Registered in: MN, PA, & TX **NICET IV - Water-Based Systems Layout
From: Sprinklerforum [mailto:[email protected]] On Behalf Of Steve Leyton Sent: Wednesday, July 13, 2016 12:02 PM To: [email protected] Subject: RE: Visual Inspection of CPVC System Conservative but not unheard of. One of the most common bad practices is to make up a bunch of pre-cut drops and clue them into branch outlets assembly-line style. If done in a hurry with too much cement, you get runs that can wholly or partially fill the sprinkler above the plug. I've seen it. SL From: Sprinklerforum [mailto:[email protected]] On Behalf Of Mike Hairfield Sent: Wednesday, July 13, 2016 9:59 AM To: [email protected]<mailto:[email protected]> Subject: Visual Inspection of CPVC System We recently had a local AHJ require a visual inspection of a CPVC system prior to doing a hydrostatic test. All places where a sprinkler head was installed they made us remove the heads for the inspection. Has anyone ever had this happen to them or am I missing something here? Thanks, Mike
_______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org
