If you are talking about L-Channel, just cut out little wedges along one of the legs, so that the metal can be flexed. If you are going to use square or rectangular channel, use a conduit bender. I know that Lowes here in Columbus Ohio, will rent one to anybody, then it's just like bending aluminum rail.
Terry Griner Who worked in home (re)construction in a 'previous life'. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Robert M. Blackson Sent: Thursday, January 19, 2006 10:24 PM To: ssls-small-scale live steam Subject: [SSLiveSteam] Raised Track Regarding Chris Scott's endorsement of aluminum channel, how do you go about bending the channel for curve sections? Using, say, one inch channel, would it not be too rigid to bend? Bob Blackson _______________________________________________ SSLiveSteam mailing list Send messages: [email protected] Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam Rules: http://www.45mm.com/sslivesteam_guide.html "This e-mail is intended for the sole use of the intended recipient and may contain privileged, sensitive, or protected health information. If you are not the intended recipient, be advised that the unauthorized use, disclosure, copying, distribution, or action taken in reliance on the contents of this communication is prohibited. If you have received this e-mail in error, please notify the sender via telephone or return e-mail and immediately delete this e-mail." _______________________________________________ SSLiveSteam mailing list Send messages: [email protected] Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam Rules: http://www.45mm.com/sslivesteam_guide.html
