Phil wrote: > I'm experiencing a weird hang when attempting to hotplug devices on a > Marvell88sx card. > > I can issue: > > cfgadmin -c disconnect <device> > > and the device is unconfigured and disconnected without problems. > > If I then replace the device (or attempt to use the same device): > > cfgadmin -c connect <device> > > the command hangs and my syslogs start filling up with: > > Apr 1 22:52:00 unknown marvell88sx: [ID 517869 kern.info] SError > interrupt > Apr 1 22:52:00 unknown marvell88sx: [ID 517869 kern.info] > 10-bit to 8-bit decode error > Apr 1 22:52:00 unknown marvell88sx: [ID 517869 kern.info] > Disparity error > > Eventually the machine becomes non-responsive. > > Attempting to re-issue the connect or disconnect commands results in: > > bash-3.2# cfgadm -c disconnect sata1/1 > Disconnect the port: /devices/[EMAIL PROTECTED],0/pci8086,[EMAIL > PROTECTED]/pci8086,[EMAIL PROTECTED],3/pci11ab,[EMAIL PROTECTED]:1 > This operation will disable activity on the SATA port > Continue (yes/no)? yes > cfgadm: Hardware specific failure: Driver ioctl failed I/O error > > > Anyone experienced this? I just tried this
cfgadm -c disconnect sata5/7 cfgadm -c connect sata5/7 and experienced no such problem. I was using sata v1.30 and marvell88sx 1.24 of Solaris Nevada (OpenSolaris). Regards, Lida > > This message posted from opensolaris.org > _______________________________________________ > storage-discuss mailing list > [email protected] > http://mail.opensolaris.org/mailman/listinfo/storage-discuss > _______________________________________________ storage-discuss mailing list [email protected] http://mail.opensolaris.org/mailman/listinfo/storage-discuss
