Hi Jim -
There is a possibility your running into CR 6687203. The bug has been
committed to the 2.5 release of software. The software will be released
in the coming months.
Hope this helps,
Mike
On 07/16/09 15:39, Bobbie wrote:
JBOD operation is supported by the cli. It is not fully functioning,
but you should be able to see the devices and obtain some information
from them via the cli. Which version are you using? 2.4 is the current.
I'd recommend obtaining the 3000 Family CLI 2.4 User's Guide.
Table A-3 contains a list of commands that will work with a JBOD
rather than the RAID controller. You would only be able to access the
JBOD
in-band, as there is no controller to set an IP address and control
out of band communications.
The Installation, Operation, and Service guide would provide proper
installation and configuration information.
The Best Practices Guide would provide recommendations for how
to use the various configurations based upon your desired results.
All of these guides are available on the download site.
Regards,
b
Jim Klimov wrote on 07/16/09 15:07:
i used these arrays (not jbods) and oem dothill variants back on
solaris 9, and got an installation working with sol 10
so yes - they work, and explorer (diag toolkit) used sccli to collect
stats successfully
sccli needs a controller i think - dont think a true jbod has one
--
<http://www.sun.com> * Michael Martinez *
Enterprise Array Engineering
*Sun Microsystems, Inc.*
500 Eldorado Blvd., Bldg. 5
Broomfield, CO 80021 USA
Phone (303) 547-3633
Email [email protected]
<http://www.sun.com>
_______________________________________________
storage-discuss mailing list
[email protected]
http://mail.opensolaris.org/mailman/listinfo/storage-discuss
