Not sure if this was the original issue, but it is also possible that DNS was giving it the 66.22.x.x IP. In my experience, many DNS servers have "DNS assistance" enabled, especially home ISPs, that redirect you to a search page when a DNS lookup to a nonexistent address is performed. The Sun Ray looks for sunray-config-servers et al. and can trigger this functionality.
William From: [email protected] [mailto:[email protected]] On Behalf Of Jeremy Loukinas Sent: Wednesday, May 23, 2012 1:03 PM To: SunRay-Users mailing list Subject: Re: [SunRay-Users] Sunray 2fs reset to factory I did setup an interconnect. I ran the command utfwadm -Aa -N all -G force to enable the GUI firmware to be pushed out. I can now open the Gui on the 2FS. I also learned you can push out the Sunray server ip in DHCP specifically with Option 49 in the DHCP scope. None the less putting it on a private interconnect and pushing out a GUI firmware with utfwadm worked 100% thanks everyone for the suggestions. On Wed, May 23, 2012 at 12:28 PM, Craig Bender <[email protected]> wrote: Could you please answer the question about the current version of firmware? If you setup a private interconnect, then it should be handing out firmware. By default it will be the non-gui version. But if the unit has firmware that is newer than what you have, you'll have to follow the steps in the admin guide to downgrade the firmware. The commands are also in the admin guide to tell the client to use the GUI version of the firmware. On 5/23/12 7:17 AM, Jeremy Loukinas wrote: I set them on a priv interconnect and via DHCP was able to point them to a test Sunray server. How would I go about pushing a GUI firmware out so that I can enable the menu on the thin client itself? The reason for going through this is I will not be able to have a private interconnect for these I will need to manually configure each unit to point at a different subnet for their server. On Tue, May 22, 2012 at 3:22 PM, Jim Klimov <[email protected] <mailto:[email protected]>> wrote: 2012-05-22 22:18, Craig Bender wrote: If you have Sun Keyboard, what does stop+v report? How do you know you have the GUI menu? Stop+C would clear any configuration. If you setup a private interconnect and use a small hub or crossover cable, you can put any firmware on there since the Sun Ray Server will control the DHCP and use vendor class tags. @Jeremy: It is possible that the DTU not only connected to a specific SRSS server, but also had static IP configuration, in its previous life. In this case it might be useful to try and determine that addressing (i.e. by sniffing on the private interconnect - which itself is the way I'd go too), and also set the target server's IP address 66.22.xx.xx on your server's interconnect interface. Craig, is it possible that a GUI firmware was installed, set up via menu, and then a non-GUI firmware was installed - but the settings saved into Flash remain in force? I guess in this case there would be no way to override that setting except by reflashing the firmware using the interconnect, as you suggested first :) HTH, //Jim ______________________________ _________________ SunRay-Users mailing list [email protected] <mailto:[email protected]> http://www.filibeto.org/ mailman/listinfo/sunray-users <http://www.filibeto.org/mailman/listinfo/sunray-users> _______________________________________________ SunRay-Users mailing list [email protected] http://www.filibeto.org/mailman/listinfo/sunray-users _______________________________________________ SunRay-Users mailing list [email protected] http://www.filibeto.org/mailman/listinfo/sunray-users
_______________________________________________ SunRay-Users mailing list [email protected] http://www.filibeto.org/mailman/listinfo/sunray-users
