As Paul Sand wrote, this is almost certainly a jumper problem. Go to your hard drive manufacturer's web site and find the installation document for your hard drive. It should have the correct jumper settings somewhere in there.
If you run into problems, feel free to post the drive manufacturer part number, and maybe we can help. You might also want to check your pci card vendor's web site to ensure that the card's bios/driver is current. Good luck -joe >Art Montes De Oca wrote: > >Hi, I just installed a ACARD AT66 pci card into my s900. I am running >os9.1 w/700+megs of ram and 2 scsi HDs. all ran well. I installed the >ata pci card and a 80gig hd and it only shows up as 32 gigs...?? I >tried formatting it w/apple utilities as well as HDtool kit. Nothing >shows more than 32 gigs. It partitions ok and runs just fine...just >missing 40 some gigs of HD! Any one have any hints? -- SuperMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | Service & Replacement Parts [EMAIL PROTECTED] | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> SuperMacs list info: <http://lowendmac.com/supermacs/list.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/supermacs%40mail.maclaunch.com/> --------------------------------------------------------------- >The Think Different Store http://www.ThinkDifferentStore.com ---------------------------------------------------------------
