Mike,

It sounds like you're doing it right but obviously something's not meshing.

Here's WD's page on jumpers in case something else here may help.

http://support.wdc.com/techinfo/general/jumpers.asp

Also, if the only ide drive being used, do you have the ide cable plugged
into the bus furthest away from the pci mounting bracket?  That is the
primary bus and what you want.  It is possible you may need a newer ATA100
cable.  

If it's the only drive present again, you might just try it as Master if
yours is different than the page description.

As someone who does a lot of testing using my ATA/66 card, for some reason,
some drives refuse to work when using the ATA/66 cable on the ATA/66 card,
but will work with ATA/100 while connected to the same card.  Go Figure!
IDE Voodoo I suppose..

Hope this helps but maybe somebody has a direct solution.

Good Luck!

Dave
G4 400 s900
Running both a Siig ATA/133 and VST Ultratek ATA/66.


-- 
SuperMacs is sponsored by <http://lowendmac.com/> and...

 Small Dog Electronics    http://www.smalldog.com  | Refurbished Drives |
 Service & Replacement Parts   [EMAIL PROTECTED]  |  & CDRWs on Sale!  |

      Support Low End Mac <http://lowendmac.com/lists/support.html>

SuperMacs list info:    <http://lowendmac.com/supermacs/list.shtml>
  --> AOL users, remove "mailto:";
Send list messages to:  <mailto:[EMAIL PROTECTED]>
To unsubscribe, email:  <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive: <http://www.mail-archive.com/supermacs%40mail.maclaunch.com/>


---------------------------------------------------------------
>The Think Different Store
http://www.ThinkDifferentStore.com
---------------------------------------------------------------


Reply via email to