On 2009-12-28 04:18, Michel Servaes wrote:
I was wondering, and am going to try this, this evening... how would an
embedded-install go onto a normal pc system ?
I downloaded the 2.0 Beta, physdiskwrite'ed it to a CF card of 2GB
Going to place it in the CF to IDE adaptor (where monowall currently
runs fine, on another CF card).
And boot the system up...
My big question - how would I tell which network interface will be the
LAN, to run the WebGUI wizard on... (on an Alix, it's the first one -
but how can I tell on this P3-600 (old compaq) board, which would be the
first one ?)
Or won't it run at all ? Any first thoughts here ?
It is named after drivers, so if you have NICs that are not using the
same driver, it is rather easy. If no, use the auto-detection... I
think the way it works is that you connect the nic you want and make
sure there is a link.
hth
Ugo
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
