On Mon, Dec 28, 2009 at 01:18, Michel Servaes <[email protected]> wrote: > I was wondering, and am going to try this, this evening... how would an > embedded-install go onto a normal pc system ? > > > I downloaded the 2.0 Beta, physdiskwrite'ed it to a CF card of 2GB > Going to place it in the CF to IDE adaptor (where monowall currently runs > fine, on another CF card). > > And boot the system up... > > > > My big question - how would I tell which network interface will be the LAN, > to run the WebGUI wizard on... (on an Alix, it's the first one - but how can > I tell on this P3-600 (old compaq) board, which would be the first one ?) > > Or won't it run at all ? Any first thoughts here ?
Hook up a monitor and keyboard. Get into the console. Plug in the one of the NICs to a switch (probably the one on your LAN). Do an ifconfig, and see which of your NICs is active. Or, since you're already running monowall, check it to see which it thinks is which - how did you figure that one out? Kurt --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
