Thanks Andrey... so if you're looking at the back of the board where the connector is, is J1-1 on the left side, or right side of the cable?
ag. On 15 March 2011 14:16, Andrey Filippov <[email protected]>wrote: > Adam, > > Older sensors we used were 10 (not 12) bit, but they required 3.3V analog > power supply voltage. For them we used switching 3.3V->5.0V converter, then > linear regulator back to 3.3V. To reduce possible interference from the > switching dc-dc converter we synchronized it it to the sensor frames. > 5MPix sensor uses lower power supply that can be linear regulated from > "dirty" 3.3V, so these 2 lines where used as extra data bits. When used in > 323 and 363 cameras more control signal were reassigned to data bits so the > data bus in that case is 14 bit wide, using the same 10313 system boards in > the 323 camera and 10353 in the 363. > > Andrey > > On Mon, Mar 14, 2011 at 7:59 PM, Adam Gobi <[email protected]>wrote: > >> Thanks Andrey, looks good. Also, I was just curious about why you have >> the Dout[0] and Dout[1] pins separate from the rest of the sensor data >> output pins, and named CNVSYNC and CNVCLK? >> >> Thanks, >> ag. >> >> >> On 15 March 2011 12:32, Andrey Filippov >> <[email protected]>wrote: >> >>> Adam, yes, the pinout is the same. The circuit diagram of the 10338D is >>> on the page http://wiki.elphel.com/index.php?title=10338D , we just did >>> not update photos there. >>> >>> Andrey >>> >>> >>> On Mon, Mar 14, 2011 at 7:13 PM, Adam Gobi <[email protected]>wrote: >>> >>>> Hi Andrey, >>>> >>>> Just looking at at the cable pinouts in 10338a.pdf, which appears to be >>>> for revision 'A'. Do they correspond with the 10338 revision 'D' board >>>> that >>>> came with my 353 camera, including the 3.3V supply voltage requirement? >>>> >>>> Thanks, >>>> ag. >>>> >>>> >>>> -- >>>> Adam Gobi >>>> Lead Engineer - Imaging >>>> Acheron Project Pty Ltd >>>> Leichhardt, NSW, Australia >>>> e: [email protected] <[email protected]> >>>> v: +61 451 951 323 >>>> f: +61 2 9571 5575 >>>> >>>> >>> >> >> >> -- >> Adam Gobi >> Lead Engineer - Imaging >> Acheron Project Pty Ltd >> Leichhardt, NSW, Australia >> e: [email protected] <[email protected]> >> v: +61 451 951 323 >> f: +61 2 9571 5575 >> >> >> _______________________________________________ >> Support-list mailing list >> [email protected] >> http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com >> >> > -- Adam Gobi Lead Engineer - Imaging Acheron Project Pty Ltd Leichhardt, NSW, Australia e: [email protected] <[email protected]> v: +61 451 951 323 f: +61 2 9571 5575
_______________________________________________ Support-list mailing list [email protected] http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
