Thanks Andrey. Is it at all possible for the board to operate with 3.3V LVTTL I/O instead of 2.5V? I noticed in the sensor datasheet that its max input HIGH voltage is 3.3V.
Best regards, ag. On 17 March 2011 03:52, Andrey Filippov <[email protected]>wrote: > Adam, > http://wiki.elphel.com/images/7/71/10338d.pdf has the PCB layout, the > connector is on the pages showing LAYER-4 (BOTTOM SIDE), the layer is shown > as seen from top side. > > On you image the pin 1 is on the bottom left side, pin 2 - on top left, pin > 3 - second from the left on bottom, etc. > These pins do not include the for mounting pins (no electrical contact) > that are in the 4 corners of the connector: > X-2-4-6...30X > X1-3-5-7...29-X > "X" - mounting pin, no connection to the cable > "-" - space > "1".."30" - electrical pin > > The cable (sensor end) when pointed sensor end up, looking at the contact > side will be numbered sequentially 1-2-3-...-29-30 > > > On Tue, Mar 15, 2011 at 10:03 PM, Adam Gobi <[email protected]>wrote: > >> Thanks for your reply Andrey, but I couldn't see what you were referring >> too. Instead, I've attached a picture to remove any potential ambiguousness >> from my original question of left, or right. >> >> Thanks, >> ag. >> >> > -- Adam Gobi Lead Engineer - Imaging Acheron Project Pty Ltd Leichhardt, NSW, Australia e: [email protected] <[email protected]> v: +61 451 951 323 f: +61 2 9571 5575
_______________________________________________ Support-list mailing list [email protected] http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
