So with the camera being programmable, and the source being available, as being
new to this device how does one go about changing the code? I’m familiar with
programming and understand most of what’s going on in the code, but am looking
at what additional software, hardware is required to compile and download new
code to the camera. The specifics I’d like to change are to either change the
signal width for the exposure timer from 16 bits (4 command bits and 12 timer
value bits) to 32 bits (same 4 command and 28 timer value bits). In doing so,
I’m sure the controller code and HTML script may need to be changed as well.
Normal (for me) code changes on the FPGA require download to the EEPROM/Flash
through the JTAG port. Code changes to the controller would be through an ISP
or JTAG connector. Are both of these devices’ code changes all handled through
the Ethernet interface?
Mitch
_______________________________________________
Support-list mailing list
Support-list@support.elphel.com
http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
