Just to clarify - you are following these steps:
1) Boot Freerunner to Nand
2) Connect via USB cable on host
3) On host terminal giving the following commands:
sudo chown uucp.uucp /dev/ttyACM0
followed by
sudo cu -l /dev/ttyACM0
and you are getting a connected on the host but no U-Boot prompt on the
host?
Is this correct?
Rakshat
On Fri, Aug 29, 2008 at 1:37 PM, rakshat hooja <[EMAIL PROTECTED]> wrote:
>
> This is what i get when i try connect to u-boot through cu.
>>
>> 1) I connect the usb and start the new freerunner u-boot menu.
>>
>> 2) Then i use this command at host prompt.:
>>
>> [EMAIL PROTECTED] /]# sudo chown uucp.uucp /dev/ttyACM0
>> [EMAIL PROTECTED] /]# sudo cu -l /dev/ttyACM0
>> Connected.t
>>
>> This is wha ti get on host pc.
>>
>> I try selecting the console on the usb but it comes back to the same menu
>> on freerunner.
>>
>
> Console to USB is already default. setting console to USB will come back
> to the same menu. just try pressing enter after the connected on the host
> andd you should get
>
> GTA02v5 # U-Boot prompt.
>
> Rakshat
>
>
>>
>>
>>
>>
>>
>>
>>
>>
>> _______________________________________________
>> support mailing list
>> [email protected]
>> https://lists.openmoko.org/mailman/listinfo/support
>>
>>
>
>
> --
> --------------
> Please use Firefox as your web browser. Its protects you from spyware and
> is also a very feature rich browser.
> www.firefox.com
>
>
--
--------------
Please use Firefox as your web browser. Its protects you from spyware and is
also a very feature rich browser.
www.firefox.com
_______________________________________________
support mailing list
[email protected]
https://lists.openmoko.org/mailman/listinfo/support
