Very strange. I just installed 0.80.4 inside vmware 5 workstation running on xp and it worked perfectly.
On 8/26/05, [EMAIL PROTECTED] <[EMAIL PROTECTED]> wrote: > > > At 10:52 AM 8/26/2005, Bill Plein wrote: > >I am getting other issues with "installer". Here is the order of events > > > >1) Boot the latest CD image (pfSense-LiveCD-0.80.iso) > >2) Allow it to come up, I assign interfaces, and finally up to the menu > >3) run "installer" > >4) Partition disk, install > >5) Reboot (from disk, not from CD, verified by watching the lights, > >looking at BIOs, belt and suspenders!) > >6) System comes up, running kernel from disk, but after kernel loads, > >it starts running the code from the CD instead of from the hard drive > > > >If I remove the CD from the drive, then I get errors. Basically what I > >am getting is a CDROM live image version installed to disk, with all > >the pointers back to the CD. > >Which means upon subsequent reboots, nothing is saved. > > > >Any ideas? > > > >As a background, I am running this on a TEST SYSTEM which is actually > >a VMWare virtual machine. The last time I tried this was around .71x > >and it worked fine. In fact, I ran a manual ugprade from .71x to .80x > >and it worked OK, but there were some wierd things going on so I > >decided to start from scratch. It's been down hill ever since. > > > >I run my real router on a WRAP platform, but like to follow the recent > >builds using the full build in a VMWare session (I actually connect > >multiple interfaces and can use it for access to the Internet, but I'd > >never run it in "production" this way) > > As a test, I went back and used the ISO for 0.71.6 (Live CD iso) and it > installed correctly. So it's not a change in hardware or my methodology. > > > > > -- > [EMAIL PROTECTED] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
