Is there anyway to turn off the microcode on a per/NIC basis? I only have older Pro100 cards - (trying to recycle some old equipment and make it usefull again)
JB On Thu, September 29, 2005 1:14 pm, Scott Ullrich wrote: > I suspect the microcode is borking the NIC. Do you have a newer > NIC that you could try? I would rather not remove the microcode > support as it works wonders for newer cards. > > Scott > > > > On 9/29/05, J B <[EMAIL PROTECTED]> wrote: > >> Well - it keeps timing out, I wish I had the machine in front of me so >> I >> could send the actual error - but it keeps saying that the microcoad >> load is timing out >> >> JB >> >> >> On Thu, September 29, 2005 1:08 pm, Dan Swartzendruber wrote: >> >>> At 12:48 PM 9/29/2005, you wrote: >>> >>> >>>> yes - it shows up as fxp0 - but then I get errors loading microcode >>>> - >>>> and it just don't work on the network >>> >>> "gets errors". can you be more specific? >>> >>> >>> >>> >>> >>> --------------------------------------------------------------------- >>> To unsubscribe, e-mail: [EMAIL PROTECTED] >>> For additional commands, e-mail: [EMAIL PROTECTED] >>> >>> >>> >>> >> >> >> >> --------------------------------------------------------------------- >> To unsubscribe, e-mail: [EMAIL PROTECTED] >> For additional commands, e-mail: [EMAIL PROTECTED] >> >> >> > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]