CARP and bridging currently do not work together.
On 6/26/06, Tristan DEFERT <[EMAIL PROTECTED]> wrote:
Hi list,
I recently moved from Linux/Debian/IPtables(shorewall) to pfSense
because of redundancy possibility with pfsync+carp.
I got two computers with the same hardware and 5 Ethernet interfaces
each.
So i set up the 5 interfaces as following:
Master FW:
LAN (private IP 192.168.33.2)
WAN (public IP my.ip.class.3)
DMZCORPORATE (bridged with WAN)
DMZCLIENTS (bridged with WAN)
SYNC (10.10.10.100 dedicaced to CARP)
Slave FW:
LAN (private IP 192.168.33.3)
WAN (public IP my.ip.class.4)
DMZCORPORATE (bridged with WAN)
DMZCLIENTS (bridged with WAN)
SYNC (10.10.10.101 dedicaced to CARP)
And Virtual IPs like this:
Virtual LAN (private IP 192.168.33.1, acting as gateway for LAN network)
Virtual WAN (public IP my.ip.class.2 with gateway my.ip.class.1
[provider router] )
My question is:
how do i setup the bridge together with virtual IPs ?
i want the Virtual WAN IP to be bridged to DMZCORPORATE and DMZCLIENTS
I'm a bit confused, and want to know if someone has already realised
such a setup.
Thx a lot for support!
Regards,
Tristan
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
