There is a static route in place, and I can traceroute etc without any issue.
> -----Original Message----- > From: Holger Bauer [mailto:[EMAIL PROTECTED] > Sent: 15 November 2006 14:16 > To: [email protected] > Subject: RE: [pfSense Support] Static Route Problem > > Try enabling static route option at system>advanced. > > Holger > > > -----Original Message----- > > From: Lawrence Farr [mailto:[EMAIL PROTECTED] > > Sent: Wednesday, November 15, 2006 1:55 PM > > To: [email protected] > > Subject: [pfSense Support] Static Route Problem > > > > I have a setup like this > > > > internet > > | > > PFSense Local > > | > > servers --- Cisco > > | > > PFSense Remote Site > > > > The local PFSense box was running a beta from about 6 months > > ago, and has a static route in place to get to the remote > > site. The Cisco and the servers are in the same subnet. > > Everything worked flawlessly until I upgraded to 1.01 > > yesterday. I did a fresh install, and restored my settings > > from the previous. Now any access from remote to a local > > server connects, but times out after a few seconds. If I add > > a static route on the server itself, it'll work. SSH works > > fine between everything, but FTP or POP3 for example don't. > > Has anything changed in PFSense that would cause this? > > > > Lawrence Farr > > EPC Direct Limited > > > > > > > --------------------------------------------------------------------- > > To unsubscribe, e-mail: [EMAIL PROTECTED] For > > additional commands, e-mail: [EMAIL PROTECTED] > > > > > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
