I talked about the option at system>advanced, it's a checkbox: Static route filtering: [X] Bypass firewall rules for traffic on the same interface This option only applies if you have defined one or more static routes. If it is enabled, traffic that enters and leaves through the same interface will not be checked by the firewall. This may be desirable in some situations where multiple subnets are connected to the same interface.
I was not talking about a route at system>static routes. Holger > -----Original Message----- > From: Lawrence Farr [mailto:[EMAIL PROTECTED] > Sent: Wednesday, November 15, 2006 3:32 PM > To: [email protected] > Subject: RE: [pfSense Support] Static Route Problem > > There is a static route in place, and I can traceroute etc > without any issue. > > > -----Original Message----- > > From: Holger Bauer [mailto:[EMAIL PROTECTED] > > Sent: 15 November 2006 14:16 > > To: [email protected] > > Subject: RE: [pfSense Support] Static Route Problem > > > > Try enabling static route option at system>advanced. > > > > Holger > > > > > -----Original Message----- > > > From: Lawrence Farr [mailto:[EMAIL PROTECTED] > > > Sent: Wednesday, November 15, 2006 1:55 PM > > > To: [email protected] > > > Subject: [pfSense Support] Static Route Problem > > > > > > I have a setup like this > > > > > > internet > > > | > > > PFSense Local > > > | > > > servers --- Cisco > > > | > > > PFSense Remote Site > > > > > > The local PFSense box was running a beta from about 6 months ago, > > > and has a static route in place to get to the remote > site. The Cisco > > > and the servers are in the same subnet. > > > Everything worked flawlessly until I upgraded to 1.01 > yesterday. I > > > did a fresh install, and restored my settings from the > previous. Now > > > any access from remote to a local server connects, but times out > > > after a few seconds. If I add a static route on the > server itself, > > > it'll work. SSH works fine between everything, but FTP or > POP3 for > > > example don't. > > > Has anything changed in PFSense that would cause this? > > > > > > Lawrence Farr > > > EPC Direct Limited > > > > > > > > > > > > --------------------------------------------------------------------- > > > To unsubscribe, e-mail: [EMAIL PROTECTED] For > > > additional commands, e-mail: [EMAIL PROTECTED] > > > > > > > > > > > > > > --------------------------------------------------------------------- > > To unsubscribe, e-mail: [EMAIL PROTECTED] For > additional > > commands, e-mail: [EMAIL PROTECTED] > > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] For > additional commands, e-mail: [EMAIL PROTECTED] > > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
