Apologies, yes that's fixed it now, many thanks. > -----Original Message----- > From: Holger Bauer [mailto:[EMAIL PROTECTED] > Sent: 15 November 2006 14:36 > To: [email protected] > Subject: RE: [pfSense Support] Static Route Problem > > I talked about the option at system>advanced, it's a checkbox: > > Static route filtering: [X] Bypass firewall rules for traffic on the > same interface > This option only applies if you have defined one or more > static routes. > If it is enabled, traffic that enters and leaves through the same > interface will not be checked by the firewall. This may be > desirable in > some situations where multiple subnets are connected to the same > interface. > > > I was not talking about a route at system>static routes. > > Holger > > > -----Original Message----- > > From: Lawrence Farr [mailto:[EMAIL PROTECTED] > > Sent: Wednesday, November 15, 2006 3:32 PM > > To: [email protected] > > Subject: RE: [pfSense Support] Static Route Problem > > > > There is a static route in place, and I can traceroute etc > > without any issue. > > > > > -----Original Message----- > > > From: Holger Bauer [mailto:[EMAIL PROTECTED] > > > Sent: 15 November 2006 14:16 > > > To: [email protected] > > > Subject: RE: [pfSense Support] Static Route Problem > > > > > > Try enabling static route option at system>advanced. > > > > > > Holger > > > > > > > -----Original Message----- > > > > From: Lawrence Farr [mailto:[EMAIL PROTECTED] > > > > Sent: Wednesday, November 15, 2006 1:55 PM > > > > To: [email protected] > > > > Subject: [pfSense Support] Static Route Problem > > > > > > > > I have a setup like this > > > > > > > > internet > > > > | > > > > PFSense Local > > > > | > > > > servers --- Cisco > > > > | > > > > PFSense Remote Site > > > > > > > > The local PFSense box was running a beta from about 6 > months ago, > > > > and has a static route in place to get to the remote > > site. The Cisco > > > > and the servers are in the same subnet. > > > > Everything worked flawlessly until I upgraded to 1.01 > > yesterday. I > > > > did a fresh install, and restored my settings from the > > previous. Now > > > > any access from remote to a local server connects, but > times out > > > > after a few seconds. If I add a static route on the > > server itself, > > > > it'll work. SSH works fine between everything, but FTP or > > POP3 for > > > > example don't. > > > > Has anything changed in PFSense that would cause this? > > > > > > > > Lawrence Farr > > > > EPC Direct Limited > > > > > > > > > > > > > > > > > > --------------------------------------------------------------------- > > > > To unsubscribe, e-mail: [EMAIL PROTECTED] For > > > > additional commands, e-mail: [EMAIL PROTECTED] > > > > > > > > > > > > > > > > > > > > > --------------------------------------------------------------------- > > > To unsubscribe, e-mail: [EMAIL PROTECTED] For > > additional > > > commands, e-mail: [EMAIL PROTECTED] > > > > > > > > > > --------------------------------------------------------------------- > > To unsubscribe, e-mail: [EMAIL PROTECTED] For > > additional commands, e-mail: [EMAIL PROTECTED] > > > > > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] >
--------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
