Done ! removed them and it works fine. I put the 2 x Dlinks into an old P4 its boots up fine !
So then the problem is the board ? processor ? Can you suggest a board that you know for certain works with either the dlinks or Intel 4 port cards ? Regards, Mike Lever Tenacity Films (Pty) Ltd t/a Velocity Films (T) +2711-807-0100 (F) 086-681-7518 http://www.velocityfilms.com CONFIDENTIALITY CAUTION: If you have received this communication in error, please note that it is intended for the addressee only, is privileged and confidential and dissemination or copying prohibited. Please notify us immediately by e-mail and return the original message. Thank you. -----Original Message----- From: Scott Ullrich [mailto:[EMAIL PROTECTED] Sent: 19 Mar 2008 07:55 PM To: [email protected] Subject: Re: [pfSense Support] Fatal trap 12 during installation On 3/19/08, Mike Lever <[EMAIL PROTECTED]> wrote: > The last line before the error is: > > ste0: <Dlink DL10050 10/100BaseTX) port 0.2100-021ff irq 11 at device 4.0 on > pci3 Try removing one of the dlink 4 port cards. I get similar panics when trying to use 2 PCI-E 4-port intel gigabit cards as well. Scott --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
