On Wed, Mar 19, 2008 at 6:56 PM, Mike Lever <[EMAIL PROTECTED]> wrote: > Done ! removed them and it works fine. I put the 2 x Dlinks into an old P4 > its boots up fine ! > > So then the problem is the board ? processor ? > > Can you suggest a board that you know for certain works with either the > dlinks or Intel 4 port cards ? > > Just make sure the board does not share interrupt with other pci slots. That would mostly take care of it.
Though it is just a suggestion. > Regards, > > > Mike Lever > > Tenacity Films (Pty) Ltd t/a > Velocity Films > > (T) +2711-807-0100 > (F) 086-681-7518 > > http://www.velocityfilms.com > > > CONFIDENTIALITY CAUTION: If you have received this communication in error, > please note that it is intended for the addressee only, is privileged and > confidential and dissemination or copying prohibited. Please notify us > immediately by e-mail and return the original message. Thank you. > > > > -----Original Message----- > From: Scott Ullrich [mailto:[EMAIL PROTECTED] > Sent: 19 Mar 2008 07:55 PM > To: [email protected] > Subject: Re: [pfSense Support] Fatal trap 12 during installation > > > > On 3/19/08, Mike Lever <[EMAIL PROTECTED]> wrote: > > The last line before the error is: > > > > ste0: <Dlink DL10050 10/100BaseTX) port 0.2100-021ff irq 11 at device 4.0 > on > > pci3 > > Try removing one of the dlink 4 port cards. I get similar panics when > trying to use 2 PCI-E 4-port intel gigabit cards as well. > > Scott > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
