On 5/26/08, Angelo Turetta <[EMAIL PROTECTED]> wrote: > I tried booting one of my NexCom NSA-1042 with a nightly RELENG_1 > (20080526-0555). As soon as the kernel loads (just after the press enter to > boot /boot/kernel/kernel), the console output stops. After some tens > seconds, I hear the usual pfSense beep, but I cannot send any command, nor > receive any feedback/menu/prompt. > Obviously I tried all the most usual serial speeds (9600,38400,115200). > The same box boots fine (serial console OK) with the nightly build > 20080525-0340 of RELENG_1_2. > > Do you think this could be a problem of FreeBSD-7 vs. FreeBSD-6? or some > missing bits in pfSense RELENG_1 boot environment? > > The box also has a syscons(4), which unfortunately is not initialized (by > design) in embedded versions (both branches). I'll try the same two CF on a > soekris net4801 (no syscons) later this week, then report back the results. > > Thanks, > Angelo. > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > >
By chance did the VGA console come up with the menu? Scott --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
