Hi,
For some time now I have been running monowall on a Wrap board on CF
without issues, however I came across some rather lovely features of
pfSense I would love to have, mainly:
* Support for my Wireless mini-pci card - Wiston
* Rule Schedules
* RDD Graphs
and more ....
However, after installing pfSense (1.2 STABLE) and getting it all
setup with my /29 range etc, I ran into a couple of small snags.
1. I have a Server called 'Max' - when adding this to the aliases (as
I have prev done under mono) I would get an error on the reload of
the config :( It would appear I am unable to add this host name as an
alias. I presume max is a reserved word ? However the only workaround
I can do is not to have an alias for this host and enter the ip
address for now - which I can live with (Just wanted to point out in
case this was a bug or error).
2. Outbound NAT - As I have 3 mail servers here, I wanted each server
to go out on its own IP address rather than the default interface
address, simple enough (and currently have working under mono) -
however as much as I try all IP's are presented as my firewall IP :(
I have the relevant entries in Virtual IPs (Proxy ARP) and set the
required rules for Outbound NAT - but they seem to get ignored,
however as I said I do have this working fine at the mo under mono so
I think its correct how I have it setup :(
Sorry to compare against mono but I understand pfSense was forked from
monowall, and to show that I have setup (many times) a lot of these
firewalls - but I may be overlooking something here ....
Any help or clarification would be appreciated.
Thanks in advance.
Matt
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
