In m0no:
Under NAT - OUTBOUND NAT I have the following entries.
INTERFACE - SOURCE - DESTINATION - TARGET - DESC
WAN - 192.168.102.3/32 - * - x.x.x.186 - Orion -> .186
WAN - 192.168.102.10/32 - * - x.x.x.187 - Pegasus -> .187
WAN - 192.168.102.2/32 - * - x.x.x.188 - Max -> .188
WAN - 192.168.102.14/32 - * - x.x.x.189 - Lyra -> .189
So if I SSH into any of these boxes and launch $> lynx
http://www.whatismyip.com - each box reports the correct WAN IP I
require... so appears to be fine.
However under pfSense - all the boxes report (using the same method
above)
.190 - which is the firewall WAN IP
Enable advanced outbound NAT - Ticked
Config looks fine. Do you have any packages installed?
Nope, just using the Embedded version onto a CF (1GB).
Matt
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
