Hi,
I'm using pfsense 1.2.2 embedded on an PC Engines ALIX.2C2 board.
My Wireless device is a Compex WLM54G23 200mW (miniPCI) card.
ath0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
ether 00:80:48:55:99:65
inet6 fe80::280:48ff:fe55:9965%ath0 prefixlen 64 scopeid 0x3
inet 10.0.0.1 netmask 0xffffff00 broadcast 10.0.0.255
media: IEEE 802.11 Wireless Ethernet autoselect mode 11b <hostap>
status: associated
ssid hotspot channel 3 (2422 Mhz 11b) bssid 00:80:48:55:99:65
authmode OPEN privacy OFF txpower 31.5 scanvalid 60 bgscan
bgscanintvl 300 bgscanidle 250 roam:rssi11b 7 roam:rate11b 1 burst
-apbridge dtimperiod 1
On my laptop i see the device like this:
Cell 03 - Address: 00:80:48:55:99:65
ESSID:"hotspot"
Mode:Master
Channel:3
Frequency:2.422 GHz (Channel 3)
Quality=42/100 Signal level:-84 dBm Noise level=-127 dBm
Encryption key:off
IE: Unknown: 0007686F7473706F74
IE: Unknown: 010482848B96
IE: Unknown: 030103
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s
Extra:tsf=000000000d9c790d
Extra: Last beacon: 4136ms ago
Picture of the setup:
http://picasaweb.google.com/elmargol/Public#5316314771640605810
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
