John Sellens wrote:
| From: Victor Padro <[email protected]>
|
| Again, use VLANs and configure the interfaces in Pfsense in order to
| adquire IPs from each subnet:
|
| LAN: 192.168.10.1(or whatever you are using)
| WAN: xy.xy.xy.10
| WAN1: ab.ab.ab.ab
| WAN2(VLAN50): xy.xy.xy.20
| WAN3(VLAN60): xy.xy.xy.30
I think that would require a vlan capable switch on the WAN side, and
I think the original poster (Jesse) said that wasn't an option from
the ISP.
I had a not-disimilar problem and eventually did some ugly things,
which I'm not very happy with, but it's a stop-gap solution for me.
I think pfSense 2.x is expected to fix this (with IP aliases), but
in the meantime I suspect you'll have to add another physical
interface on your firewall, put a little switch on the outside, and
plug your cable modem and the two WAN interfaces into the switch.
I suspect that you can't do it with VLANs, because the link from
the ISP is untagged.
Hope that helps - cheers!
John
[email protected]
Your address scheme does not make sense without subnet numbers. Anyways
I do not think you can have the same gateway for all your three interfaces.
Eugene.
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
