On Thu, 12 Aug 1999 23:42:32 -0400, Tibor Mocsar wrote:
> I was very disappointed when I saw that Arachne could
> not recognise the S3 chip. Not only that, it has
> absolutely refused to work with the card on a 800x600
> resolution. The provided VESA 2.0 driver didn't help
> anything.
Newer cards usually already have built-in firmware VESA
driver in ROM, so software-based VESA driver no longer
needed (just select VESA in Arachne setup). Otherwise,
a generic VESA driver like UNIVBE might help.
> with other programs, too. I had to replace it with my
> old ET4000 1MB card. Does anybody know a solution
> (beside throwing it away)?
Instead of throwing it away, how about trade it in for
an ET6000? ;)
--Eko
To unsubscribe from SURVPC send a message to [EMAIL PROTECTED] with
unsubscribe SURVPC in the body of the message.
Also, trim this footer from any quoted replies.
