Don't know if this table will come thru semi-intact in plain text format. If not, it can be found at http://www.esf.edu/willow/news2/n2why.htm
Species Density Heat Value lb/cu. ft. lb/cord BTU/lb Million BTUs/ton Million BTUs/cord Willow 23.7 3,034 8,400 16.8 25.2 Sugar Maple 39.1 5,005 8,400 16.8 42.0 Red Maple 34.3 4,390 8,400 16.8 36.9 American Beach 39.1 5,005 8,600 17.2 43.0 Eastern Cottonwood 25.9 3,315 8,800 17.2 29.2 Red Oak 39.8 5,094 9,360 18.6 47.6 * all values are based on oven dry weight One Full Cord = 128 cubic feet Willow Yields 5-8 tons / acre, non-irrigated Coal yields 20,974,000 BTUs / short ton One acre = 208.71' x 208.71' Using the same conversion rate for willow as exists for coal, 10,452 Btu's / KwH, one mean acre of willow yields 10,447 KwH's. One acre, 209' x 209', is sufficient to supply ~1.19 homes consuming 1Kw each hour for an entire year. Todd Swearingen ----- Original Message ----- From: Harmon Seaver To: biofuel@yahoogroups.com Sent: Monday, February 25, 2002 10:01 AM Subject: Re: [biofuel] Re: Cornburning Stoves Pellets, according to the figures on www.premiumpellet.com are 40.6 lb @ cubic foot, whereas a lot of hardwoods are denser, some oaks over 50-60 lb @ cubic foot. Pellets are definitely densified, but often are made from aspen or softwoods. Pellets offer a lot of advantages, such as convenience, cleanliness, and a very controlled, constant rate of burn, no creosote, etc., but I don't think you can say they have more energy content than, say, oak or hickory. harley94xl wrote: >--- In [EMAIL PROTECTED], MH <[EMAIL PROTECTED]> wrote: > >>I'm of the understanding that pressurized wood pellets are >> >approximately twice > >>as dense. So the energy content would be approx. twice as >> >much ??? And require > >>about half as much storage volume then cord wood. Corrections are >> >welcomed. > >If you burn hard woods, for example Oak, it takes 0.7 cords of wood >to make 18,000,000 BTU's. If you burn a premium wood pellet with >less than 1% ash, it takes about 1 ton of pellets to make 18,000,000 >BTU's of output. 1 ton of wood pellets fit on a skid about 6' by 6' >cube. Compare that to how much a ² cord of wood piled up would >take. The information is compiled from 2 internet sources. > >http://www.cornburner.com/BM620-9.html > Some of the cost figures here are not very accurate, or at least not accurate for all areas. Most charts give $150 @ full cord of wood (which is correct hereabouts anyway) not $115. And I've seen $1.73 @ bushel for corn, not sure about the others. > >and >http://www.premiumpellet.com/pellet_analysis.htm > >If anyone is interested in the chart I devised, I can sent it up to >an internet website for people to look at and examine themselves. > > >Jeremy > > > > -- Harmon Seaver CyberShamanix http://www.cybershamanix.com Biofuel at Journey to Forever: http://journeytoforever.org/biofuel.html Please do NOT send "unsubscribe" messages to the list address. To unsubscribe, send an email to: [EMAIL PROTECTED] Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. [Non-text portions of this message have been removed] ------------------------ Yahoo! Groups Sponsor ---------------------~--> Buy Stock for $4. No Minimums. FREE Money 2002. http://us.click.yahoo.com/BgmYkB/VovDAA/ySSFAA/FGYolB/TM ---------------------------------------------------------------------~-> Biofuel at Journey to Forever: http://journeytoforever.org/biofuel.html Please do NOT send "unsubscribe" messages to the list address. To unsubscribe, send an email to: [EMAIL PROTECTED] Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/