Yes , it will work that way - my druthers is that you have
HV at the handle instead of probe. If I was doing it ;
everything off ; attach probe and no hands on it ( keepa U
handa offa ) ; fire up and read ; disconnect power ; remove
probe when zero volts.
Best: Eugene

Joe Dickerson wrote:
> 
> Eeeerrr, that's why I always place the "clip" of the probe on the cap
> and the "point" of the probe to ground. The probe will NOT kick back the
> wrong way because it is reversed.
> Joe
> 
> Eugene Spooner wrote:
> >   Eeeeeerrrrrrr ; that HV is a Negative Voltage to the case
> > and HV probe meter would kick the wrong way. Just have got
> > to be careful with that stuff as it has "Punch" !
> > Best: Eugene
> >
> > Joe Dickerson wrote:
> >
> >>Joe,
> >>   Did you check the high voltage rectifier and the H.V. capacitor?
> >>Also, check the magnetron. There should be low resistance across the two
> >>pins.
> >>To check the H.V. getting to the magnetron, clip the ground lead of the
> >>high voltage probe to ground reference and touch the point of the probe
> >>to ground to see if there is high voltage there. This may be obvious to
> >>you, but I don't know how much training you've had in microwave. Just
> >>trying to help.lol
> >>
> >>Joe
> >>
> >>Joe Tech2004 wrote:
> >>
> >>>Sharp microwave R-508AK mfd-1998
> >>>
> >>>Above unit belongs to my mother who lives in Detroit, where I am at now,
> >>>I had an earlier problem awhile back with the magnetron kept running
> >>>even when unit was off...
> >>>
> >>>Fix Was: Stuck relay from power surge, removed outer relay housing
> >>>cleaned
> >>>carbon from contacts... BINGO....
> >>>
> >>>Now current problem: Unit powers up but doesn't heat.
> >>>
> >>>Little fuse type CES6 20Amp mounted to the metal shield was blown, I
> >>>temporarily replaced with 15Amp car fuse (all i had wasn't planning on
> >>>this). Anyway fuse doesn't blow but unit still no heat. Sticker inside
> >>>states when replacing that fuse to also replace monitor switch, which
> >>>i'm not sure which is monitor switch, All three switches that operate
> >>>via door opening & closing check fine. I am not in a very good
> >>>serviceable position working on her kitchen counter so please bear with
> >>>me.
> >>>
> >>>There is what appears to be a relay on the front control panel board
> >>>lower left corner, the best i can make out any writing around this on
> >>>the board is
> >>>
> >>>RY2/HB2/ACCOM & on component itself i can make out DU1PU. If i unplug
> >>>red wire going to this no changes, but unplug black wire total shut down
> >>>(obviously main ground..??) my meter reads up to 20 meg-ohm & unit
> >>>checks open but how can that be if when I lift the black wire i get
> >>>total shutdown, i'm wondering if this is my problem & also what switch
> >>>are they referring to when they say replace monitor switch along with
> >>>little fuse. One last thing the component (relay..??) i've been
> >>>referring to does have a slight melted spot in plastic housing (may be
> >>>my problem or from last problem with power surge) i'm returning home
> >>>friday 07/09/04 so i would like to try to fix this before i leave.
> >>>
> >>>Any & All suggestions I would greatly appreciate. Thanks Group "joe"
> >>>
> >>>Joes....Electronics
> >>> (Joe:Tech/2004)
> >>>[EMAIL PROTECTED]
> >>>Fax::509-479-2283
> >>>
> >>>
> >>>_______________________________________________
> >>>Tech Repair CD...order your just $49.00 plus shipping...One year of updates free.
> >>>www.intrepid-video.com www.tech-repair.net
> >>>Techs mailing list
> >>>[EMAIL PROTECTED]
> >>>http://intrepid-video.com/mailman/listinfo/techs_intrepid-video.com
> >>>
> >>
> >>--
> >>Joe Dickerson
> >>Joe's TV & Appliance
> >>Rt 1 Box 3781
> >>Jasper, Texas 75951
> >>(409) 384-3325
> >>use same no. for fax
> >>
> >>_______________________________________________
> >>Tech Repair CD...order your just $49.00 plus shipping...One year of updates free.
> >>www.intrepid-video.com www.tech-repair.net
> >>Techs mailing list
> >>[EMAIL PROTECTED]
> >>http://intrepid-video.com/mailman/listinfo/techs_intrepid-video.com
> >
> >
> 
> --
> Joe Dickerson
> Joe's TV & Appliance
> Rt 1 Box 3781
> Jasper, Texas 75951
> (409) 384-3325
> use same no. for fax
> 
> _______________________________________________
> Tech Repair CD...order your just $49.00 plus shipping...One year of updates free.
> www.intrepid-video.com www.tech-repair.net
> Techs mailing list
> [EMAIL PROTECTED]
> http://intrepid-video.com/mailman/listinfo/techs_intrepid-video.com

-- 
Head Witch Doctor and Chief Bottle Washer
Eugene Spooner , CET , AAS , NP
Eugene's Carry-In TV
1417 Eastway Drive
Charlotte , NC 28205
mailto:[EMAIL PROTECTED]

_______________________________________________
Tech Repair CD...order your just $49.00 plus shipping...One year of updates free.
www.intrepid-video.com www.tech-repair.net
Techs mailing list
[EMAIL PROTECTED]
http://intrepid-video.com/mailman/listinfo/techs_intrepid-video.com

Reply via email to