Hi Said, Good! But upsetting when sellers do not do their due diligence to properly pack and therefore damage equipment that would have been just fine. I was very upset, and at the end very lucky when I bought my 8657B, which was shipped bare in a large box with what must have been not more than a dozen peanuts thrown in. The beautiful instrument was damaged, but luckily it was easily fixed. It could have been MUCH worse.
I think the single shot *resolution* of the TIC is 20pS, but in my experience the jitter is quite a bit more. So I think 50 pS STDEV with only 100 averages is in the ballpark. Both of mine (5370A) are out of commission at the moment because of either poor sockets or tin whiskers, maybe both. For both units, I can take the chips out of the sockets and put them back in, and the instruments will work for a while, then they will loose their brains again. I have planned to replace the sockets, but have not come around to it yet. I use the 5334B in the mean time. You may want to run it through the cal because there are a lot of things that can go wrong without providing obvious clues on these counters. Didier [EMAIL PROTECTED] wrote: > > In a message dated 6/8/2007 18:43:32 Pacific Daylight Time, [EMAIL PROTECTED] > > writes: > > >> Well, his listing includes the serial number. He would not use the same >> listing without at least updating the S/N? >> > > >> Didier >> > > > > Hi Didier, I just got an email from him, he changed the picks today after I > asked him about it. The original listings didn't include the SN's. > > I got my unit today, and the left handle is almost broken off. He didn't use > bubblewrap :( If you guys order from him, make sure to require him to use > 1.5 - 2 inches of bubblewrap all around the unit. > > The standard deviation of a 15ns cable-delayed signal is measured as 50ps in > 100 averages. > > Is that a good number for these units? I was expecting <20ps. > > The frequency is in error of parts to the E-09 with an external 10MHz Cs > reference. > > Maybe the unit just needs to be calibrated? Maybe it got shipping damage? > > bye, > Said > > > > ************************************** See what's free at http://www.aol.com. > _______________________________________________ > time-nuts mailing list > [email protected] > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > _______________________________________________ time-nuts mailing list [email protected] https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
